Fit contains a set of adaptable rectification suggestions which are auto-populated at the beginning of the workflow. You can alter these pre-set suggestions and the system will adapt the other modifications accordingly. As these modifications are edited, the suggestions will become more defined.

The results of the suggestions are automatically previewed on the limb in the centre Main 3D viewport. You can alter the selection placement and size using control points for each modification.

The suggestions can be exported as an STL file for use in CAD software’s or directly into riiForm.

Toggles all selection previews on/off.

Generates a new set of suggestions, taking into account locked and disabled modifications.

Resets all suggestions to the ones generated at the beginning of the workflow.

Can be edited with manual input or by dragging the slider bubble.

Toggles the suggestion, setting its value to 0. A disabled suggestion won’t change when new suggestions are generated.

Locks the suggestion amount so that it won’t adapt to other suggestion changes. This also toggles slider input on/off.

Add control point to selection or remove control point from selection

Set a selection as active by clicking on its suggestion. This will enable control points for that selection on the limb, where the user may move/resize to refine the selection area.

Change the suggestion amount by dragging the slider bubble. The blue at the start/end of each slider represents a category change, meaning it will effect other suggestions when new suggestions are generated.