Scan Cleanup
Overview
Remove artifact, fill holes, and ensure your scan is consistent and compatible with riiForm’s tools by cleaning up your scan.
Additional Features
- Use planes to cut off artifacts
- Straighten a flexed scan
- Fills holes in scans
- Option to extend the proximal height of the scan
Video Tutorial
Tool Structure
Utility Bar
Wireframe
Toggle the wireframe of your scan.
Reset
Reset scan cleanup, plane cut-off height, and mesh extension. This will reset all adjustments made within the tool.
Tool Body
Proximal Straightening (°)
Use the slider bar to straighten a flexed limb scan.
Plane cut-off height (mm)
Set a height to cut off the scan when cleaned up.
Extend mesh height above MPT (mm)
Extend the height of the scan when cleaned up.
Note: There needs to be at least 120mm above the MPT to receive all modification recommendations from the Fit workflow. The software will automatically extend the height if the distance between the plane cut-off and MPT is less than 120mm.
How to Use
- Straighten a flexed scan by moving the slider bar. The red line will adjust as the slider bar moves and the straightening will be applied when the bar is released. (optional)
- Set the Plane cut-off height to remove proximal artifacts. After using the slider bar to move the plane down, the scan will turn red. Everything in red will remain after clicking Cleanup Scan.
- Set the proximal height above MPT (optional but will be applied automatically if there is less than 120mm above MPT).
- Advanced properties - toggle on additional planes to help remove artifacts. (optional)
- Click the Scan Cleanup button to cleanup the scan.
Did this answer your question?
😞
😐
🤩